User Manual

Connecting an MP to an MX Switch
Chapter 3
Installing and Connecting an MP-620 Access Point
25
Figure 11. Connecting Cables to the Power Injector
3 Insert the power cable plug directly into the standard AC receptacle on the
power injector.
4 Plug the other end of the power cable into a grounded, 3-pin socket, AC
power source.
5 Check the LED on top of the power injector to be sure that power is being
supplied to the MP-620 through the Ethernet connection.
Connecting an MP to an MX Switch
You can connect an MP access point directly to an MX switch or indirectly to the
switch through an intermediate Layer 2 or Layer 3 network.
● To connect the MP directly to an MX switch, configure the MX switch port as
an MP access port and use the following procedure to insert the cable into the
MX switch and verify the link.
● To connect the MP indirectly to an MX switch though the network, configure
a Distributed MP connection on the MX switch.
Note. For International use, you may need to change the AC line cord. You
must use a line cord set that has been approved for the receptacle type in your
country.
Input
Output
Ethernet cable
from LAN switch
Ethernet cable to
MP-620
AC power
Power LED indicator