Network Router User Manual

Chapter 13
Connecting, Grounding, and Powering On
the SRX210 Services Gateway
This chapter includes the following topics:
■ Connecting the SRX210 Services Gateway to the Power Supply on page 81
■ Connecting and Organizing Interface Cables to the SRX210 Services
Gateway on page 83
■ Grounding the SRX210 Services Gateway on page 84
■ Powering On and Powering Off the SRX210 Services Gateway on page 85
Connecting the SRX210 Services Gateway to the Power Supply
To connect the device to the power supply:
CAUTION: Before connecting the device to the power supply, attach an ESD strap
to an ESD point and place the other end of the strap around your bare wrist.
NOTE: If you are installing your services gateway on a desk, ensure that your device
is adequately grounded using the grounding point on the back panel of the chassis.
1. Plug the DC connector end of the power cable into the power connector on the
back of the device (see Figure 25 on page 82).
2. Plug the AC adapter end of the power cable into an AC power outlet.
Connecting the SRX210 Services Gateway to the Power Supply ■ 81