Network Router User Manual
Figure 25: Connecting the SRX210 Services Gateway to the Power Supply
NOTE: The device must be connected to earth ground during normal operation. The
protective earthing terminal on the rear of the chassis is provided to connect the
device to ground.
CAUTION: We recommend using a surge protector for the power connection.
NOTE: Use the cable tie holder to secure the power cord on to the power supply
point.
NOTE: We strongly recommend that you use only the 3-pin power cord supplied
with your services gateway. If you are using a 2-pin power cord, then ensure that
your device is adequately grounded using the grounding point available on back
panel of chassis.
Related Topics ■ Required Tools and Parts for Installing and Maintaining the SRX210 Services
Gateway on page 59
■ Grounding the SRX210 Services Gateway on page 84
■ Connecting and Organizing Interface Cables to the SRX210 Services Gateway
on page 83
■ SRX210 Services Gateway General Safety Guidelines and Warnings on page 133
82 ■ Connecting the SRX210 Services Gateway to the Power Supply
SRX210 Services Gateway Hardware Guide