Network Router User Manual

To ground the device:
1. Connect the grounding cable to a proper earth ground.
2. Verify that a licensed electrician has attached the cable lug to the grounding
cable.
3. Place the grounding cable lug over the grounding point on the upper rear of the
chassis.
4. Secure the grounding cable lug to the grounding point with the screw.
5. Dress the grounding cable and verify that it does not touch or block access to
the services gateway components and that it does not cause anyone to trip on
it.
NOTE: The device should be permanently connected to ground during normal
operation.
Related Topics ■ Connecting the SRX210 Services Gateway to the Power Supply on page 81
■ Connecting and Organizing Interface Cables to the SRX210 Services Gateway
on page 83
■ SRX210 Services Gateway Grounding Specifications on page 159
■ Powering On and Powering Off the SRX210 Services Gateway on page 85
■ SRX210 Services Gateway General Safety Guidelines and Warnings on page 133
Powering On and Powering Off the SRX210 Services Gateway
This topic describes the following procedures:
1. Powering On the SRX210 Services Gateway on page 85
2. Powering Off the SRX210 Services Gateway on page 86
3. Resetting the SRX210 Services Gateway on page 87
Powering On the SRX210 Services Gateway
To power on the services gateway:
1. Ensure that you have connected the power supply to the device.
2. Insert the plug of the power supply adapter into an AC power source receptacle.
3. Turn on the power to the AC power receptacle.
The device starts automatically as the power supply completes its startup sequence.
The Power LED lights up during startup and remains on steadily when the device is
operating normally.
Powering On and Powering Off the SRX210 Services Gateway ■ 85
Chapter 13: Connecting, Grounding, and Powering On the SRX210 Services Gateway