Network Router User Manual

NOTE: To remove power completely from the device, unplug the AC power cord or
switch off the power source.
After powering off a power supply, wait at least 10 seconds before turning it back
on. After powering on a power supply, wait at least 10 seconds before turning it off.
The Power button on the services gateway is a standby power switch.
If you press the Power button to power off the device when it is still connected to a
power source, 12 V (Low Memory and High Memory models) /48 V (PoE and Voice
models) power will still be available in the chassis and the device will be fully powered
off.
TIP: When you are powering off the device, the system displays the following
message: Turning the system power off. You can now safely remove the power cable
to completely disconnect the power from the device.
NOTE: You can use the request system reboot CLI command to schedule a reboot
of the services gateway using request system reboot.
For more information about halting, powering off, or rebooting the services gateway
using CLI, see the JUNOS Software Administration Guide.
Resetting the SRX210 Services Gateway
The Reset Config button located at the front panel of the SRX210 Services Gateway
removes the current configuration and resets the device to the default configuration.
The button is recessed in the front panel to prevent it from being pressed accidentally.
NOTE: Pressing and holding the Reset Config button for 15 seconds or more deletes
all configurations on the device and loads and commits the factory configuration.
Related Topics Connecting the SRX210 Services Gateway to the Power Supply on page 81
Grounding the SRX210 Services Gateway on page 84
SRX210 Services Gateway Front Panel and Back Panel Views (Low Memory, High
Memory and PoE Version) on page 10
Using the Reset Config Button on the SRX210 Services Gateway on page 126
SRX210 Services Gateway LEDs on page 18
Resetting the SRX210 Services Gateway 87
Chapter 13: Connecting, Grounding, and Powering On the SRX210 Services Gateway