Network Router User Manual

Related Topics ■ Connecting an SRX210 Services Gateway to the CLI Locally on page 95
■ Performing Initial Software Configuration on the SRX210 Services Gateway Using
the CLI on page 104
■ Connecting an SRX210 Services Gateway to the J-Web Interface on page 91
■ SRX210 Services Gateway Software Configuration Overview on page 101
■ SRX210 Services Gateway Secure Web Access Overview on page 111
Connecting the Modem at the SRX210 Services Gateway End
NOTE: These instructions use Hayes-compatible modem commands to configure the
modem. If your modem is not Hayes-compatible, refer to the documentation for
your modem and enter the equivalent modem commands.
To configure the modem on the services gateway end:
1. Connect the modem to a PC or laptop computer.
2. Power on the modem.
3. From the PC or laptop computer, start your asynchronous terminal emulation
application (such as Microsoft Windows HyperTerminal) and select the COM port
to which the modem is connected (for example, COM1).
4. Configure the port settings shown in Table 35 on page 97.
Table 35: Port Settings to Configure the Modem on the Services Gateway End
ValuePort Settings
9600Bits per second
8Data bits
NoneParity
1Stop bits
NoneFlow control
5.
In the HyperTerminal window, enter AT.
For more information on the AT commands, see the JUNOS Software
Administration Guide.
An OK response verifies that the modem can communicate successfully with the
COM port on the PC or laptop.
6.
Configure the modem to answer a call on the first ring by entering ATS0=1.
Connecting the Modem at the SRX210 Services Gateway End ■ 97
Chapter 15: Connecting the SRX210 Services Gateway to Management Devices