Network Router User Manual

NOTE: If an IP address is not assigned to the management device, manually configure
an IP address in the 192.168.1.0/24 subnetwork. Do not assign the 192.168.1.1 IP
address to the management device, as this IP address is assigned to the device.
4. Access the J-Web interface:
a. Launch a Web browser from the management device.
b. Enter 192.168.1.1 in the Address box.
c. Specify the default user name as root. Do not enter any value in the Password
box.
d.
Press Enter. The J-Web Initial Setup page is displayed.
5. Configure the basic settings such as Host Name, Domain Name, Root Password,
and IP Address for your services gateway. Ensure that you have configured the
IP address, root authentication, and default gateway before you apply the
configuration.
NOTE: All network and management access settings are optional.
6. Click Apply to apply the configuration.
NOTE: After configuring the basic settings, the Web session may timeout. Refresh
or relaunch the page if the applied configuration page is not displayed .
Configuring Basic System Properties
Table 39 on page 108 through Table 41 on page 110 provide the summary of
configuration details for initial setup.
Table 39: Basic Configuration Summary (Device Identification)
Your ActionFunctionField
Type the hostname.Defines the hostname of the
services gateway.
Host Name
Type the domain name.Defines the network or subnetwork
that the services gateway belongs
to.
Domain Name
108 ■ Configuring Basic System Properties
SRX210 Services Gateway Hardware Guide