Network Router User Manual

Table 39: Basic Configuration Summary (Device Identification) (continued)
Your ActionFunctionField
Type a plaintext password that the
system encrypts.
NOTE: After a root password has been
defined, it is required when you log in
to the J-Web user interface or the CLI.
Sets the password that user root
can use to log in to the services
gateway.
Root Password
(required)
Retype the password.Verifies the root password has
been typed correctly.
Verify Root
Password
(required)
Add an IP address by selecting it in the
box to the left of the Add button, then
clicking Add.
Delete an IP address by clicking it in the
box above the Add button, then clicking
Remove.
Specifies a DNS server that the
services gateway can use to resolve
hostnames into addresses.
DNS Name
Servers
Add a domain name by typing it in the
box to the left of the Add button, then
clicking Add.
Delete a domain name by , clicking it
in the box above the Add button, then
clicking Remove.
Adds each domain name that
includes the services gateway to
the configuration so that each
domain is included in a DNS
search.
Domain Search
Table 40: Basic Configuration Summary (Management Access)
Your ActionFunctionField
Type a 32-bit IP address in
dotted decimal notation.
Defines a default gateway through which
to direct packets addressed to networks
not explicitly listed in the routing table.
Default Gateway
Type a 32-bit IP address and
prefix length in dotted decimal
notation.
Defines a reserved IP address that is
always available on the services gateway.
If no address is entered, this address is
set to 127.0.0.1/32.
Loopback Address
Enable Telnet access by
selecting the box.
Allows remote access to the services
gateway using Telnet.
Allow Telnet
Access
Enable JUNOScript access over
cleartext by selecting the box.
Allows JUNOScript to access the services
gateway using a protocol for sending
unencrypted text over a TCP connection.
Allow JUNOScript
over Clear-Text
Access
Enable SSH access by selecting
the box.
Allows remote access to the services
gateway using SSH.
Allow SSH Access
Configuring Basic System Properties ■ 109
Chapter 16: Performing Initial Software Configuration on the SRX210 Services Gateway