Network Router User Manual

Table 41: Basic Configuration Summary (Date and Time)
Your ActionFunctionField
Date and Time
From the list, select the appropriate time zone.Identifies the time zone in
which the services gateway is
located.
Time Zone
Add an IP address by clicking Add and entering
IP address and then clicking OK.
Delete an IP address by clicking it in the box and
then clicking Delete.
Specifies an NTP server that
the services gateway can reach
to synchronize the system
time.
NTP Servers
■
Set the time immediately using the NTP
server; select NTP Servers. The services
gateway sends a request to the NTP server
and synchronizes the system time.
NOTE: If you are configuring other settings on
this page, the services gateway also synchronizes
the system time using the NTP server when you
click OK.
■
Set the time manually by selecting the
Manual button. A window allows you to
select the current date and time from lists.
Synchronizes the system time
with the NTP server or allows
you to manually set the system
time and date.
Current
System
Time
To configure basic system properties:
1. In the J-Web interface, select Configure> System properties and select the
required tab and proceed with configuring the other settings. See Table 39 on
page 108 through Table 41 on page 110 for details.
2. Click one of the following buttons:
■ Click OK to save changes.
■ Click Cancel to cancel your entries and return to the previous page.
■ Click Commit to apply the configuration and other pending changes (if any)
and click Discard to discard pending changes.
3. Configure an interface as follows:
a. In the J-Web interface, select Configure>Interfaces
The Interfaces page appears and lists the network interfaces present on the
services gateway.
b. Under the Interface Name column, click the interface you want to configure
(for example ge-0/0/0).
c. Under Logical Interfaces, click Add.
d. Under IPv4 Addresses and Prefixes, click Add.
110 ■ Configuring Basic System Properties
SRX210 Services Gateway Hardware Guide