Network Router User Manual
Table 10: SRX210 Services Gateway Built-In Hardware Interfaces (continued)
DescriptionSpecificationsInterface Type
The USB ports can be used as
follows:
■
To support a USB storage
device that functions as
a secondary boot device
in case of the internal
flash failure on startup, if
the USB storage device is
installed and configured
NOTE: You must install and
configure the USB storage
device on the USB port to use
it as secondary boot device.
Also, the USB device must
have JUNOS installed.
■
To provide the USB
interfaces that are used
to communicate with
many types of Juniper
supported USB storage
devices.
Contact your Juniper Networks
customer service
representative for more
information.
■
Consist of two ports
■
Function in full speed and
high speed
■
Are compliant with USB
revision 2.0
Universal Serial Bus (USB)
The console port can be used
as follows:
■
To provide the console
interface
■
To function as a
management port to log
into a device directly
■
To configure the device
using the CLI
■
Consists of one port
■
Uses an RJ-45 serial cable
connector
■
Supports the RS-232
(EIA-232) standard
Console
16 ■ SRX210 Services Gateway Built-In Interfaces
SRX210 Services Gateway Hardware Guide