Network Router User Manual

Install the device as appropriate for your site using one of the following procedures:
■ Adjusting the Power Supply Adapter Tray for the SRX210 Services Gateway for
Rack-Mount Installation on page 70
■ Installing the SRX210 Services Gateway in a Rack on page 71
■ Installing the SRX210 Services Gateway on a Desk on page 75
■ Installing the SRX210 Services Gateway on a Wall on page 76
Adjusting the Power Supply Adapter Tray for the SRX210 Services Gateway for Rack-Mount
Installation
This topic provides details on the power supply adapters provided with different
models of the SRX210 Services Gateway and the procedure for adjusting the power
supply adapter tray to hold the power supply adapter.
The following power supply adapters are provided with the SRX210 Services Gateway:
■ 60-watt power supply adapter for the SRX210 Services Gateway Low Memory
and High Memory models
■ 150-watt power supply adapter for the SRX210 Services Gateway with PoE and
the SRX210 Services Gateway with Integrated Convergence Services
To adjust the power supply adapter tray:
■ To accommodate the 60-watt power supply, use the two 420–028535 screws to
attach the adapter stopper brackets at the point on the chassis marked B.
Figure 15 on page 70 shows the adjustments to the power supply adapter tray
required for the 60-watt power supply.
Figure 15: Adjusting the Power Supply Adapter Tray to Accommodate the 60-Watt
Power Supply
1. Locations for the adapter stopper brackets in the power supply adapter tray
2. Fully configured power supply adapter tray
70 ■ Adjusting the Power Supply Adapter Tray for the SRX210 Services Gateway for Rack-Mount Installation
SRX210 Services Gateway Hardware Guide