Network Router User Manual

NOTE:
■ If you are installing multiple devices in one rack, install the lowest one first and
proceed upward in the rack.
■ Ensure that the rubber feet from the base of the chassis are removed for rack
installation.
To install the device in a rack:
1. Position a mounting bracket on each side of the chassis as shown in Figure 17
on page 72.
Figure 17: Installation of SRX210 Services Gateway in a Rack — Positioning Mounting
Brackets
Table 31 on page 72 lists the parts used for installing the SRX210 Services
Gateway on the rack. The numbers in Figure 17 on page 72 correspond to the
numbers in Table 31 on page 72.
Table 31: SRX210 Services Gateway Rack Installation Parts
PartS.No
Mounting brackets1
Screws (mounting bracket)2
Power supply adapter tray3
Adapter stopper bracket4
2. Use a number-1 Phillips screwdriver to install the screws that secure the mounting
brackets and power supply adapter tray to the chassis as shown in Figure 18 on
page 73.
72 ■ Installing the SRX210 Services Gateway in a Rack
SRX210 Services Gateway Hardware Guide