Network Router User Manual

Installing the SRX210 Services Gateway on a Desk
Follow these guidelines when installing the device on a desk:
■ You can install the SRX210 Services Gateway on a desk, table, or other level
surface.
■ The device is shipped with the rubber feet attached. The rubber feet are necessary
to stabilize the device on the desk.
■ You can install the device in a horizontal or vertical position.
■ The vertical position requires the vertical installation kit, which consists of a
vertical installation stand with the rubber feet attached.
NOTE: The desk-mounting kit is not shipped with the device and must be ordered
separately.
To install the device in a horizontal position:
The horizontal position is the standard installation position and does not require the
vertical installation kit.
1. Make sure that the rubber feet are attached to the chassis.
2. Place the device on a desk with the Juniper Networks logo embossed on the top
cover facing up.
To install the device in a vertical position:
1. Place the device on a flat and level surface with the Juniper Networks logo
embossed on the top cover facing up.
2. Attach the vertical stand to the right side of the chassis using the specified screws
as shown in Figure 21 on page 75.
Figure 21: SRX210 Services Gateway Desk Installation — Attaching Vertical Stand
3. Place the chassis vertically on the desk with the stand resting on the desk as
shown in Figure 22 on page 76.
Installing the SRX210 Services Gateway on a Desk ■ 75
Chapter 12: Installing the SRX210 Services Gateway