Network Router User Manual

1. Place the device on a flat and level surface with Juniper Networks logo embossed
on the top cover facing up. Ensure that rubber feet are attached to the bottom
of the chassis.
2. Position a mounting bracket on each side of the chassis as shown in Figure 23
on page 77.
Figure 23: SRX210 Services Gateway Wall Installation — Attaching Mounting Brackets
Table 32 on page 77 lists the parts used for installing the SRX210 Services
Gateway on a wall. The numbers in Figure 23 on page 77 correspond to the
numbers in Table 32 on page 77.
Table 32: SRX210 Services Gateway Wall Installation Parts
PartNumbers
Mounting brackets1
Screws (mounting bracket)2
3. Use a number-1 Phillips screwdriver to install the screws that secure the mounting
brackets to the chassis.
4. If you are using wall anchors to support the chassis, install two pairs of anchors
on the wall with the mounting brackets attached.
5. Have one person grasp the sides of the device, lift it, and position it on the wall.
6. Have a second person install two pairs of mounting screws through the bracket
holes on either side of the device to secure it to the wall.
7. Verify that the mounting screws on one side are aligned with the mounting
screws on the opposite side and that the device is level (see Figure 24 on
page 78).
Installing the SRX210 Services Gateway on a Wall ■ 77
Chapter 12: Installing the SRX210 Services Gateway