Network Router User Manual

The Mini-Physical Interface Module (Mini-PIM) slot is covered with a blank faceplate
to maintain proper airflow through the services gateway. Before installing the
Mini-PIM, you must remove the faceplate.
See the SRX Series Services Gateways for the Branch Physical Interface Modules
Hardware Guide for information about installing Mini-PIMs.
NOTE: The Mini-PIMs available on the SRX210 Services Gateway are not
hot-swappable. You need to power off the device before removing or installing
Mini-PIMs.
Related Topics ■ SRX210 Services Gateway Installation Safety Guidelines and Warnings on page 138
■ Installing the SRX210 Services Gateway on a Desk on page 75
■ Installing the SRX210 Services Gateway on a Wall on page 76
■ Installing the SRX210 Services Gateway in a Rack on page 71
Replacing or Installing Mini-Physical Interface Modules in the SRX210 Services Gateway ■ 79
Chapter 12: Installing the SRX210 Services Gateway