Terms and Conditions

Table Of Contents

Figure 2: WLA532E Hardware Dimensions

NOTE: The WLA532E access point requires only hardware installation. All

configurations for the access point are done on the wireless LAN controllers

(WLCs).

You configure the access point with the Juniper Networks WLC Series Wireless LAN

Controllers, through the Juniper Networks RingMaster graphical user interface or the

Juniper Networks Mobility System Software (MSS) CLI.

This topic covers:

•

Features Supported by the WLA532E Access Point on page 4

•

Physical Specifications of the Access Point on page 4

•

Hardware Mounting Options for the Access Point on page 5

•

Software and Hardware Used with the Access Point on page 6

Features Supported by the WLA532E Access Point

Features supported by the access point include:

•

Up to 450Mbps transmission—WLA532E spatial stream access point can support

data rates of up to 450-Mbps in a 5-GHz band with 40-MHz channel bonding and a

short-guard interval. On a 3x3bgn 2.4-GHz band with 20-MHz channel width, the access

point supports up to 195-Mbps by default with standard guard-interval and supports

up to 216.7-Mbps with short guard-interval.

•

In-band spectrum monitoring and network spectrum mitigation—The access point

supplies in-band RF-detect functionality to include spectrum analysis to detect and

classify the non-IEEE 802.11 sources of interference.

•

Rate adaptation feature with 3 spatial stream (SS) rates, 2 spatial stream rates and

1 spatial stream rates—The access point supports 3 SS, 2 SS and 1 SS rates and provides

and full support for rate adaptation with 3 SS clients.

Physical Specifications of the Access Point

Physical characteristics of the access point include:

WLA532E Access Point Hardware Documentation