Terms and Conditions
Table Of Contents
- Table of Contents
- List of Figures
- List of Tables
- About This Topic Collection
- Part 1: Access Point Overview and Components
- Part 2: Planning for Access Point Installation
- Part 3: Safety Guidelines and Standards for Access Point Installation
- Part 4: Requirements and Certifications
- Part 5: Installing, Connecting, and Verifying the Access Point
- Chapter 7: Installing and Connecting the Access Point
- Installation Instructions Warning
- Unpacking a WLA532E Access Point
- Parts Inventory (Packing List) for a WLA532E Access Point
- Installing the WLA532E Access Point on a Ceiling Rail
- Installing the WLA532E Access Point Using the Plenum Bracket Kit
- Installing the WLA532E Access Point on a Ceiling Rail Using the Trapeze Legacy Mounting Bracket Adapter Kit
- Installing the WLA532E Access Point on the Wall Using the WLA-BRKT-WALL Wall-Mount Kit
- Installing the WLA532E Access Point on the Wall Using the WLA-GNGWLBX-ADP-EU Wall-Mount Kit
- Installing the WLA532E Access Point on the Wall Using the WLA-GNGWLBX-ADP-NA Wall-Mount Kit
- Connecting the Access Point to Wireless LAN Controllers
- Chapter 8: Verifying the Health of the Access Point
- Chapter 9: Customer Support
- Chapter 7: Installing and Connecting the Access Point
Table 7: Site Preparation Checklist (continued)
DatePerformed ByFor More InformationItem or Task
If you are installing the access point
in a wireless LAN mesh or wireless
bridge configuration, you must
configure the access point before
deploying the access point in the
final location. To configure the
access point connection, use the
RingMaster GUI or the Mobility
System Software CLI.
See Mobility System Software
Configuration Guide at
http:// www .juniper .net/te chpubs/ en_US/rele ase-independent/ wirele ss/
informa tion-products/ pa thway-pages/ wirel ess-lan/ software-80 .html.
Configure the Access Point Connection
Related
Documentation
General Safety Guidelines and Warnings on page 23•
• General Site Guidelines on page 17
General Site Guidelines
This topic applies to hardware devices in the WLA Series.
Efficient device operation requires proper site planning and maintenance and proper
installation of the equipment using brackets, adapters and other hardware from
installation kits.
To plan and create an acceptable operating environment for your device and prevent
environmentally caused equipment failures:
•
Keep the area around the access point free from dust and conductive material.
•
Follow prescribed installation and safety guidelines to ensure that the access point is
properly installed and not at risk for causing damage to the hardware or falling to
potentially cause bodily harm.
•
Follow the prescribed environmental requirements and specifications to avoid damaging
the equipment.
•
Install the device in a secure area, so that only authorized personnel can access the
device.
Related
Documentation
Environmental Requirements and Specifications for the WLA532E Access Point on
page 18
•
• Medical Safety Compliance for WLA Series Access Points on page 25
17Copyright © 2012, Juniper Networks, Inc.
Chapter 3: Site Preparation