Terms and Conditions
Table Of Contents
- Table of Contents
- List of Figures
- List of Tables
- About This Topic Collection
- Part 1: Access Point Overview and Components
- Part 2: Planning for Access Point Installation
- Part 3: Safety Guidelines and Standards for Access Point Installation
- Part 4: Requirements and Certifications
- Part 5: Installing, Connecting, and Verifying the Access Point
- Chapter 7: Installing and Connecting the Access Point
- Installation Instructions Warning
- Unpacking a WLA532E Access Point
- Parts Inventory (Packing List) for a WLA532E Access Point
- Installing the WLA532E Access Point on a Ceiling Rail
- Installing the WLA532E Access Point Using the Plenum Bracket Kit
- Installing the WLA532E Access Point on a Ceiling Rail Using the Trapeze Legacy Mounting Bracket Adapter Kit
- Installing the WLA532E Access Point on the Wall Using the WLA-BRKT-WALL Wall-Mount Kit
- Installing the WLA532E Access Point on the Wall Using the WLA-GNGWLBX-ADP-EU Wall-Mount Kit
- Installing the WLA532E Access Point on the Wall Using the WLA-GNGWLBX-ADP-NA Wall-Mount Kit
- Connecting the Access Point to Wireless LAN Controllers
- Chapter 8: Verifying the Health of the Access Point
- Chapter 9: Customer Support
- Chapter 7: Installing and Connecting the Access Point
To install the WLA532E on a suspended ceiling rail using the legacy mounting bracket
adapter:
1. Remove the WLA522 from the installed mounted position by unlocking the universal
mounting bracket from the access point by inserting the lock/unlock tool into the
Unlock hole (see Figure 18 on page 58).
NOTE: Usea small-pointed instrument or a paperclip to unlock the access
point. Do not use a screwdriver as it can cause damage to the access point
lock mechanism or electronic components. Do not use excessive force
when using the tool to lock or unlock the universal mounting bracket.
Figure 18: Unlocking the Universal Mounting Bracket
2. Remove the WLA522 from the universal mounting bracket by pulling the access point
forward. See
3. Remove the Category 5e cable from the WLA522. The universal mounting bracket is
now exposed in a locked position on the ceiling T-bar. See Figure 19 on page 58
Figure 19: The Exposed WLA522 Universal Mounting Bracket on the Ceiling
T-bar
4. Ensure that two M3 pan head threaded mounting screws are installed on the bracket
to provide earthquake safety standards qualification. See Figure 20 on page 59 for
the mounting screws location on the universal mounting bracket.
Copyright © 2012, Juniper Networks, Inc.58
WLA532E Access Point Hardware Documentation