Terms and Conditions
Table Of Contents
- Table of Contents
- List of Figures
- List of Tables
- About This Topic Collection
- Part 1: Access Point Overview and Components
- Part 2: Planning for Access Point Installation
- Part 3: Safety Guidelines and Standards for Access Point Installation
- Part 4: Requirements and Certifications
- Part 5: Installing, Connecting, and Verifying the Access Point
- Chapter 7: Installing and Connecting the Access Point
- Installation Instructions Warning
- Unpacking a WLA532E Access Point
- Parts Inventory (Packing List) for a WLA532E Access Point
- Installing the WLA532E Access Point on a Ceiling Rail
- Installing the WLA532E Access Point Using the Plenum Bracket Kit
- Installing the WLA532E Access Point on a Ceiling Rail Using the Trapeze Legacy Mounting Bracket Adapter Kit
- Installing the WLA532E Access Point on the Wall Using the WLA-BRKT-WALL Wall-Mount Kit
- Installing the WLA532E Access Point on the Wall Using the WLA-GNGWLBX-ADP-EU Wall-Mount Kit
- Installing the WLA532E Access Point on the Wall Using the WLA-GNGWLBX-ADP-NA Wall-Mount Kit
- Connecting the Access Point to Wireless LAN Controllers
- Chapter 8: Verifying the Health of the Access Point
- Chapter 9: Customer Support
- Chapter 7: Installing and Connecting the Access Point
To install the access point on the wall:
1. Use the provided WLA532E wall-mount template to determine your anchor mounting
location (see Figure 32 on page 66) and install the wall anchors (not included in the
WLA-BRKT-WALL kit).
Figure 32: Use the Provided Template to Install Wall Anchors
2. Hold the wall-mount bracket centered over the wall anchors and pull the installed
Category 5 cable through the wall-mount bracket (see Figure 33 on page 67).
Copyright © 2012, Juniper Networks, Inc.66
WLA532E Access Point Hardware Documentation