Terms and Conditions
Table Of Contents
- Table of Contents
- List of Figures
- List of Tables
- About This Topic Collection
- Part 1: Access Point Overview and Components
- Part 2: Planning for Access Point Installation
- Part 3: Safety Guidelines and Standards for Access Point Installation
- Part 4: Requirements and Certifications
- Part 5: Installing, Connecting, and Verifying the Access Point
- Chapter 7: Installing and Connecting the Access Point
- Installation Instructions Warning
- Unpacking a WLA532E Access Point
- Parts Inventory (Packing List) for a WLA532E Access Point
- Installing the WLA532E Access Point on a Ceiling Rail
- Installing the WLA532E Access Point Using the Plenum Bracket Kit
- Installing the WLA532E Access Point on a Ceiling Rail Using the Trapeze Legacy Mounting Bracket Adapter Kit
- Installing the WLA532E Access Point on the Wall Using the WLA-BRKT-WALL Wall-Mount Kit
- Installing the WLA532E Access Point on the Wall Using the WLA-GNGWLBX-ADP-EU Wall-Mount Kit
- Installing the WLA532E Access Point on the Wall Using the WLA-GNGWLBX-ADP-NA Wall-Mount Kit
- Connecting the Access Point to Wireless LAN Controllers
- Chapter 8: Verifying the Health of the Access Point
- Chapter 9: Customer Support
- Chapter 7: Installing and Connecting the Access Point
Figure 33: Pull the Category 5 Cable Through the Wall Bracket
3. Install the bracket to the anchors using M3 or 6-32 wall anchors (see Figure 34 on
page 67).
Figure 34: Use M3 or 6-32 Wall Anchors to Secure the Bracket to Anchors
4. Align the faceplate with the installed wall-mount bracket and secure the faceplate
using the two provided flat-tip screws and the screwdriver (see Figure 35 on page 68).
67Copyright © 2012, Juniper Networks, Inc.
Chapter 7: Installing and Connecting the Access Point