Certification Exhibit FCC ID: VSF24243 ACS Project Number: 15-0093 5015 B.U.
AQG-10072-01 FL6500 Series Quick Guide INTRODUCTION The following information contains operating instructions for the Sensus FieldLogic® Hand-Held Device [HHD], which is primarily designed to collect and store utility meter readings with built-in capability for expanded uses. The HHD interfaces to a personal computer [PC] through Wi-Fi® or an ethernet-enabled charging stand used for uploading pre-programmed meter reading route information.
AQG-10072-01 FL6500 Series Quick Guide GETTING STARTED HOME SCREEN/WINDOWS START MENU If this is the first time using the FL650x, you will need to do the following. Once you have powered on the FL650X, a Home screen will appear similar to the one seen here. 1. Install the battery pack. The FL650X uses a rechargeable LiIon battery pack. The battery compartment is accessed from the back of the handheld as shown in the diagram on page 1.
AQG-10072-01 FL6500 Series Quick Guide NAVIGATION The Windows® Embedded Handheld operating system enhances the ability of the handheld to recognize touch gestures, making it easy to use a finger to navigate. The keyboard or the stylus also can be used. Navigation options vary depending on the screen you are viewing. VERTICAL AND HORIZONTAL MOVEMENT • Flick up, down, or sideways on the touchscreen. • For more precise positioning, touch, hold, and move the screen up or down.
AQG-10072-01 FL6500 Series Quick Guide COMPLIANCE Attention! Any changes or modifications made to this device that are not expressly approved by Sensus may void the authority granted to the user to operate the equipment. Attention! Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
