Reference Guide User guide

Installing a CF or SD card. To operate a card, insert the card

into the appropriate card slot, located under the standard

cap of the Field PC. (See the instructions in the previous

section for removing the standard cap.) The system should

automatically detect and use the card. However, if the card is

not recognized, try the following:

1. Install an appropriate driver by following the directions

on the device screen.

2. Operate the card by consulting the user’s guide that

came with the card.

Reinserting or changing a CF or SD card. Whenever you

remove or change a CF or SD card on the Field PC, wait at

least 6 seconds before inserting another card into the slot.

The Field PC needs this short time delay to properly identify

and use the newly inserted card. If a card is re-inserted

too quickly, the Field PC may need to reset. To avoid this

problem, close all programs

before changing or re-inserting

a card.

Copying data from a CF card,

SD card, or USB drive.

You

can run or copy data from a

peripheral device onto your

Field PC by following these

steps:

1. On the Field PC, tap Start >

Programs > File Explorer.

2. Tap and hold the  le you

want to copy to your Field

PC. A pop-up menu appears, as shown here. Note: If you

want to copy multiple  les, tap and drag the stylus over the

 les. Once the  les are selected, tap and hold the stylus on the

 les until a pop-up menu appears.