User Manual

Install the Router and Configure Software
Connect the Router to Management and Alarm Devices
11 9
Figure 46: Reinstall a Power Supply
Connect the Router to Management and Alarm Devices
After you have installed the router into the rack, connect the Routing Engine to one or more
external devices for management and service operations. Figure 47 shows the location of the
Routing Engine interface ports and alarm relay contacts on the craft interface. For
specifications for the cable and wire that inserts into the ports, see “Routing Engine Interface
Cable and Wire Specifications” on page 53.
Figure 47: Routing Engine Interface Ports on the Craft Interface
To connect external devices, perform the procedures described in the following sections:
 Connect to a Network for Out-of-Band Management on page 120
 Connect to a Management Console or Auxiliary Device on page 120
 Connect to an External Alarm-Reporting Device on page 121
1035
Safety interlock lever
Captive
screw
Extractor/inserter
FAIL OK FAIL OK FAIL OK FAIL OK FAIL OK FAIL
01234567
OK
FAIL
MANAGEMENT
ETHERNET
ROUTING ENGINE
CONSOLE
AUXILIARY
OK
MENU
ENTER
ALARM
RED
ALARM
ALARM
CUTOFF
NC
C
NO
NC
C
NO
YELLOW
ALARM
FAIL OK FAIL OK
1065
Routing Engine portsAlarm relay contacts