User Guide

Onboard Devices
You'll need to onboard devices to iniate a periodic (daily) data transfer from the devices to the Juniper Cloud. Here's
how to onboard devices in a JSI setup that uses an LWC:
NOTE: You must be an admin user to onboard a device.
Here's how to onboard devices to JSI:
1. On Juniper Support Portal, click Insights > Device Onboarding.
2. Click New Device Group. The following image represents the device onboarding page with some sample data lled
in.
3. In the Device Group secon, enter the following details for the devices to be associated with the LWC:
• Name—A name for the device group. A Device Group is a collecon of devices with a set of common credenals
and modes of connecon. The operaonal dashboards and reports use the device groups to provide a segmented
view of the data.
• IP Address—IP addresses of the devices to be onboarded. You can provide a single IP address or a list of IP
addresses. Alternavely, you can upload the IP addresses through a CSV le.
• Collector Name—Automacally populated if you have only a single LWC. If you have mulple LWCs, select from
the list of available LWCs.
• Site ID—Automacally populated if you have only a single Site ID. If you have mulple Site IDs, select from the
list of available Site IDs.
11