User guide

FIPS Device Status LED Behavior
There are three device status LEDs located on the FIPS card:
•
S (Status)
•
F (FIPS)
•
I (INIT)
Table 7: Status LED
DescriptionColor and StateLED
Bootstrap firmware is executingOffSTATUS
IDLE, OPERATIONAL, or FAILSAFE stateBlinking green
POST or DISABLED state (driver not attached)Green
Error occurred during boot processBlinking red
HALTED (fatal error) state or when a low-level
hardware initialization failure occurred
Red
Operating in non-FIPS modeOffFIPS
Operating in FIPS modeGreen
Zeroize jumper is presentBlinking yellow
Board is not initializedOffINIT
Board initialized by security officerGreen
POST, DIAGNOSTIC or FAILSAFE (firmware not
upgraded) state
Yellow
Running diagnosticsBlinking yellow
Related
Documentation
• FIPS Overview on page 9
51Copyright © 2012, Juniper Networks, Inc.
Chapter 12: LED Behavior