Datasheet

Copyright © 2010, Juniper Networks, Inc. 9
APPLICATION NOTE - Configuring the CX111 for the SSG Series
set route 0.0.0.0/0 gateway 198.1.1.2
set policy id 6 name “Management Access” from “Trust” to “Management” “Any”
“Any” “HTTP” nat src permit log
exit
set policy id 3 name “Any Permit” from “Trust” to “Untrust” “Any” “Any” “ANY”
nat src permit log count
exit
The probe status can be obtained from the “get interface monitor” command.
SSG5-> get interface ethernet0/0 monitor track-ip
ip address intval threshold wei gateway fail-count success
198.0.0.1 5 3 255 0.0.0.0 0 74%
failure weight: 255, threshold: 1, not failed: 0 ip(s) failed, weighted sum = 0
Monitoring
The 3G signal strength and connection status can be monitored from the bridge’s management interface, which
is found under status -> device info tab. The signal strength bars are only displayed for 3G modems that support
Dynamic Signal Strength.
Figure 6: Modem status
Traffic statistics can be found under the Status->Statistics page.
Figure 7: Modem statistics