Datasheet

WX 15, WX 20, and WXC 250 Quick Start
2. Connect the network cables.
 Locate the cable that connects from the switch (or other
aggregating device) to the router.
 Disconnect this cable from the router port and connect it to
the LOCAL port on the WX/WXC device.
 Connect a straight-through cable (not provided) from the
router port to the REMOTE port on the WX/WXC device.
See Figure 2.
Figure 2. Connecting network cables to a WX/WXC device
3. Verify connectivity across the WX/WXC device.
One method of testing connectivity between devices is to Ping a
host on the remote side of the device from a host on the local side
of the device.
NOTE: If you are not able to verify connectivity on both sides of the
device, do not proceed to the next step. Ensure that you are using
the correct cables (crossover vs. straight-through), and verify that
there is network connectivity before applying power.
4. Connect the power.
Connect the power cable to the back of the chassis, and then
connect the other end of the power cable to your local power
source (Figure 3).
NOTE: The power usage is 50 Watts Max or 170 BTU/hr for the
WX 15, and 150 Watts Max or 510 BTU/hr for the WX 20 and
WXC 250.
STOP: You may be able to use the autodeployment feature of the
WX CMS software to configure the device automatically. Refer to
the CMS administrator’s guide for more information or continue
with Step 5.
Figure 3. Connecting power to a WX/WXC device
TTW_047
100/240V 50-60 ~ 1/.5A
BYPASS
DISABLE
Model No. SR-15 PERIBIT NETWORKS
||||||||||||||||||||||||||||||||||||||||||||||||||
S/N 0123456789
CONSOLE
LOCAL REMOTE
LINK
LINK
100/10
100/10
LINK
LINK
100/10
100/10
LOCAL
REMOTE
Router (remote device)
WX 15
Switch (local device)
TTW_048
100/240V 50-60 ~ 1/.5A
BYPASS
DISABLE
Model No. SR-15 PERIBIT NETWORKS
||||||||||||||||||||||||||||||||||||||||||||||||||
S/N 0123456789
LOCAL REMOTE
LINK
LINK
100/10
100/10
CONSOLE