JKI 2038 JKI 4038 JKI 4068 GEBRAUCHSANWEISUNG OPERATING INSTRUCTION D t 2222745-96
t Safety Instructions Please read these operating instructions carefully before installing the appliance. These warnings are provided in the interests of your safety. Ensure you fully understand them before installing or using the appliance. If you are unsure about the meaning of these warnings contact the Customer Care Department. Domestic Use ¥ The domestic refrigerators and freezers are designed to be used specifically for the storage of edible foodstuffs only.
Instructions for the use of the instructions booklet Notes which are important for your safety or for the proper functioning of the appliance Supplementary information regarding operation and practical applications of the appliance.
¥ To remove the internal shelf pull forward until it can be tipped up or down and removed. ¥ Some models are equipped with a variable storage box which is fitted under a door shelf compartment and can be slid sideways. ¥ Please do the same in reverse to insert the shelf at a different height. depending on the model ¥ For better use of space, the front half-shelves can lie over the rear ones.
¥ Butter & cheese: these should be placed in special airtight containers or wrapped in aluminium foil or polythene bags to keep out as much air as possible. ¥ Milk bottles: these should have a top and should be stored in the bottle rack on the door. Bananas, potatoes, onions and garlic, if not packed, must not be kept in the refrigerator. Maintenance Unplug the appliance before carrying out any maintenance operation.
Cleaning Changing the light bulb Never use metal objects for cleaning your appliance as it may get damaged. NEVER use detergents, abrasive powders, highly perfumed cleaning products or wax polishes to clean the interior as these will damage the surface and leave a strong odour. Clean the inside with warm water and bicarbonate of soda. Rinse and dry thoroughly.
Customer service and spare parts If you cannot find the remedy for a malfunction in these operating instructions, please contact your dealer or our customer service department and consult the Guarantee card. Selective ordering of replacement parts can save unnecessary travel and costs. For this reason always provide the following appliance information: ¥ Model Name ¥ Model Number (PNC) ¥ Serial Number (S-No.) This information can be found on the rating plate inside the cabenit on the left hand wall.
Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. Important The appliance must be earthed. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed.
Building-in Dimensions of the recess JKI 2038/JKI 4038 JKI 4068 Height of housing (1) 880 Depth of housing (2) 550 Width of housing (3) 560 1225 550 560 mm mm mm 3. Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position.
6. Place guide (A) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes. After having drilled holes, fix the guide with the screws supplied. 9. Should the lining up of the furniture door be necessary, use the clearance of slots. At the end of operations, it is necessary to check if the door of the furniture closes properly. 50mm A 20m m PR168 PR166 7. Fix cover (C) on guide (A) until it clips into place. 10.
923631707 / 923631708 / 923527607
