Cut Sheet

DIMENSIONS
PRODUCT CODES
Catalog Number Description Actual Length Finish
T2WH 2’ Trac Section 19
7
⁄8” White
T2BL 2’ Trac Section 19
7
⁄8” Black
T2SL 2’ Trac Section 19
7
⁄8” Silver
T2NA 2’ Trac Section 19
7
⁄8” Natural
T4WH 4’ Trac Section 43
7
⁄8” White
T4BL 4’ Trac Section 43
7
⁄8” Black
T4SL 4’ Trac Section 43
7
⁄8” Silver
T4NA 4’ Trac Section 43
7
⁄8” Natural
T6WH 6’ Trac Section 67
7
⁄8” White
T6BL 6’ Trac Section 67
7
⁄8” Black
T6SL 6’ Trac Section 67
7
⁄8” Silver
T6NA 6’ Trac Section 67
7
⁄8” Natural
T8WH 8’ Trac Section 91
7
⁄8” White
T8BL 8’ Trac Section 91
7
⁄8” Black
T8SL 8’ Trac Section 91
7
⁄8” Silver
T8NA 8’ Trac Section 91
7
⁄8” Natural
T12WH 12’ Trac Section 139
7
⁄8” White
T12BL 12’ Trac Section 139
7
⁄8” Black
T12SL 12’ Trac Section 139
7
⁄8” Silver
T12NA 12’ Trac Section 139
7
⁄8” Natural
TRAC-MASTER
®
One Circuit Trac System
TRAC SECTIONS, JOINERS & FEEDS
T2, T4, T6, T8 and T12
D1.1.0
Project:
Fixture Type:
Location:
Contact/Phone:
REV-7/14
PRODUCT DESCRIPTION
Low-Profile, single-circuit trac sections for surface or pendant
mounting. I-beam cross section provides added strength and
rigidity in pendant suspended applications. Compatible with
a full range of feed, connector and mounting accessories, as
listed on back of this page, to complete virtually any installation
requirement. Accepts all Trac-Master and Trac-Lites trac fixtures.
PRODUCT SPECIFICATIONS
Construction Extruded aluminum “I” beam channel • One-piece
thermoplastic insulator • Injection molded polycarbonate dead-
end with set screw • Standard lengths may be cut-to-length by
installer.
Electrical Two 12 gauge solid copper conductors • Rated 20
amps at 120 volts • Aluminum channel used as system ground
• One-piece insulator insures consistent conductor spacing
for reliable electrical contact • Insulating bushings supplied at
mounting hole locations to prevent shorts to ground.
Labels UL listed, CSA certified.
PRODUCT INSTALLATION
Debossed polarity line provides visual cue to proper trac, trac
connector and fixture alignment • Supplied with toggle bolts
for surface mounting • Integral raceway in top of channel
accommodates pendant mounting hardware and wire routing to
electrical feed • Insulator stays same length as extrusion to simplify
field-cutting of trac • Connectors and feeds simply push into trac
sections.
Product specifications subject to change without notice.