Cut Sheet

1300 S. Wolf Road • Des Plaines, IL 60018 • Phone [phone] • Fax [phone] • Visit us at www.acuitybrands.com/juno-recessed
Printed in U.S.A. ©2017 Acuity Brands Lighting, Inc. Rev. 03/01/17
1 of 2
Project:
Fixture Type:
Location:
Contact/Phone:
4”LOW VOLTAGE UNIVERSAL
TC REMODEL HOUSING,
ELECTRONIC TRANSFORMER
50W MR16
TC44R (E1)
G3.2.8
DIMENSIONS
ACCESSORIES
Catalog No. Description
SMPLT4 4” Housing Locator
To order, specify catalog number.
5 1/4"
4 3/4"
10 1/2"
PRODUCT DESCRIPTION
TC Remodel Housing for remodel application where back side
of ceiling is not accessible • Installs through an opening in the
ceiling from below • Secured in place by factory installed remodel
springs • Designed for use in non-insulated areas • If installed
where insulation is present, the insulation must be pulled back 3”
from all sides of the TC Housing.
PRODUCT SPECIFICATIONS
Lamp One 12V, 50W MR16 lamp.
Socket Ceramic bi-pin socket with aluminum heat shield.
Trims Trim selection shown on reverse.
Transformer 120V to 12V Class 2 electronic transformer
mounted to junction box • Hatch part no. RS12-60 provided.
Dimming May be dimmed using dimmers specifically designed
for low voltage electronic transformers; consult factory or dimmer
manufacturer for additional information.
Labels U.L. listed for through-branch wiring, damp locations and
IP • Product thermally protected against improper use of lamps
or insulation • Union made • UL Listed/CSA certified • Trim
No. 441, 4401, 4402 and 4481 are wet location approved for
covered ceiling applications.
Testing All reports are based on published industry procedures;
field performance may differ from laboratory performance.
Specifications subject to change without notice.
INSTALLATION
Junction Box Pre-wired junction box, UL listed/CSA certified for
through-branch wiring maximum 4 No. 12 AWG 90˚ C branch
circuit conductors (2 in, 2 out) • Junction box provided with
removable access plate, (3)
1
⁄2” knockouts, (2) Non-metallic
sheathed cable connectors and ground wire • Knockouts
equipped with pryout slots.
Housing TC housing, 22 gauge galvanized steel • Remodel
springs accommodate up to a 1
1
/
8
” ceiling thickness.
4 3/8” CEILING CUTOUT
PRODUCT CODES
Catalog Number Input Voltage Lamp Rating
TC44R E1
4" Low Voltage Remodel Non-IC 120V 12V 50W MR16
Housing and trim can be ordered together or separate, but will always ship separately.