user manual Fridge-Freezer JCF84181
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com CONTENTS 2 4 4 5 6 Care and cleaning 7 What to do if… 8 Technical data 10 Installation 11 Environmental concerns 15 Subject to change without notice In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings.
electrolux 3 Warning! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel. • • • • 1. Power cord must not be lengthened. 2. Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or damaged power plug may overheat and cause a fire. 3. Make sure that you can come to the mains plug of the appliance. 4. Do not pull the mains cable. 5.
electrolux either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. The materials used on this appliance marked by the symbol are recyclable.
electrolux 5 Important! Do not use detergents or abrasive powders, as these will damage the finish. DAILY USE Freezing fresh food The freezer compartment is suitable for freezing fresh food and storing frozen and deep-frozen food for a long time. To freeze fresh foods it is not necessary to change the medium setting. However, for a faster freezing operation, turn the temperature regulator toward higher settings to obtain the maximum coldness.
electrolux Bottle holder The bottle holder hooked onto one of the internal shelves can be used to store bottles or cans. To remove this holder, lift the back of the shelf, press and pull it out. Slide the holder out and refit the shelf. Humidity control The glass shelf incorporates a device with slits (adjustable by means of a sliding lever), which makes it possible to regulate the temperature in the vegetable drawer(s).
electrolux 7 causing frost or ice on the evaporator. If this happens, set the Temperature Regulator toward warmer settings to allow automatic defrosting and so a saving in electricity consumption.
electrolux • rinse and dry thoroughly. Important! Do not pull, move or damage any pipes and/or cables inside the cabinet. Never use detergents, abrasive powders, highly perfumed cleaning products or wax polishes to clean the interior as this will damage the surface and leave a strong odour. Clean the condenser (black grill) and the compressor at the back of the appliance with a brush or a vacuum cleaner. This operation will improve the performance of the appliance and save electricity consumption.
electrolux 9 Problem Possible cause The compressor operates continually The Temperature Regulator may be set incorrectly Solution Set a warmer temperature The door does not close tightly or Check if the doors close well and it is not shut properly the gaskets are undamaged and clean The door has been opened too frequently Do not leave the door open longer than necessary Food placed in the appliance was too warm Allow food to cool to room temperature before storing The temperature of the room that c
electrolux Problem Possible cause Solution The door does not close tightly or Check if the door closes well and it is not shut properly the gasket is undamaged and clean Large quantities of food to be fro- Insert smaller quantities of food to zen were put in at the same time be frozen at any one time. It is too cold inside the freezer Food placed in the appliance was too warm Allow food to cool to room temperature before storing.
electrolux 11 The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. INSTALLATION Read the "Safety Information" carefully for your safety and correct operation of the appliance before installing the appliance. 5. Loosen the lower pin.
electrolux Ventilation requirements The airflow behind the appliance must be sufficient. min. 200 cm2 min. 200 cm2 Installing the appliance Caution! Make sure that the mains cable can move freely. Do these steps. 1. Apply the adhesive sealing strip to the appliance as shown in figure. 2. Install the appliance in the niche. Push the appliance in the direction of the arrows (1) until the upper gap cover stops against the kitchen furniture.
electrolux 13 4mm 44mm 4. Attach the appliance to the niche with 4 screws. 6. Attach the covers (C, D) to the lugs and the hinge holes. Install the vent grille (B). Attach the hinge covers (E) to the hinge. D C I E E 5. Remove the correct part from the hinge cover (E). Make sure to remove the part DX, in the case of right hinge, SX in opposite case. B 7. If the appliance must connect laterally to the kitchen furniture door: a) Slacken the screws in fixing brackets (H). b) Move the brackets (H).
electrolux Ha Hc 8. Disconnect the parts Ha, Hb, Hc and Hd Ha 11. Open the appliance door and the kitchen furniture door at an angle of 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes. Hb 8 mm Hc Hd 9. Install the part Ha on the inner side of the kitchen furniture. Hb 12. Remove the brackets and mark a distance of 8 mm from the outer edge of the door where the nail must be fitted (K). ca. 50 mm 90° 21 mm 90° ca.
electrolux 15 14. Press the part Hd on the part Hb. 8 mm Hb K Ha Hd 13. Place the small square on the guide again and fix it with the screws supplied. Align the kitchen furniture door and the appliance door by adjusting the part Hb. Do a final check to make sure that: • All screws are tightened. • The magnetic sealing strip is attached tightly to the cabinet. Hb ENVIRONMENTAL CONCERNS The symbol on the product or on its packaging indicates that this product may not be treated as household waste.
www.electrolux.