Montage- und Gebrauchsanweisung für den Dunstabzug Instruction on mounting and use of the cooker hood JDA 5330 1
Abb. 1 Fig. 1 D A D Abb. 2 - Fig. 2 B B C F C C Abb. 3 - Fig.
F E Abb. 4 - Fig. 4 H S G Abb. 5 - Fig. 5 S Abb. 6 - Fig.
underneath the hood. The use of an unprotected flame is dangerous for the filters and could cause fires. Therefore, never use an open flame under the hood. When frying foods, never leave the pan alone because the cooking oil could flare up. — Please, keep to the provisions of official directives regarding the question of fume discharge. — The manufacturers refuse to accept any responsibility for damage to the hood or its catching on fire because of failure to observe the above instructions.
ventilator (left switch) and one for illuminating the work surface (right switch). Fixing the hood Apply the scheme supplied (Nº 49A) on the right of the cabinet so that the lines marked by the arrows match the cabinet ensuring that they meet at the back and under. Make two Ø 2 mm holes at points 1 and 2 (fig. 4). Carry out the same operation on the left. Fix the hood to the cabinet using screws E (4,5x16) supplied with the appliance (fig. 4).
Replacing the lamps — Disconnect the hood from the electricity. — Opening the Light Cover Support (fig. 6) a. Remove the pull-out drawer completely. b. Push the B knobs inwards toward each other (in the “Open” direction as indicated on the plastic knob itself). — Always replace burnt-out lamps with olive shaped lamps max 40Watts-E14. — Re-close the light cover support. — Before calling for Repair Service because the hood fails to light up, make sure the lamp is well-inserted.
ELECTROLUX HAUSGERÄTE GMBH Rennbahnstraße 72-74 60528 Frankfurt L 921 Ed.
