Montagevorschrift und Gebrauchsanleitung für den Dunstabzug Instructions on mounting and use of the cooker hood JDI 8940
1 2 3 2 3 N M M L M L
Abb. 6 Fig. 6 Abb. 5 Fig. 5 P Abb. 7 Fig. 7 Abb. 8 Fig. 8 O Q R S Abb. 9 Fig. 9 Abb. 10 Fig.
Abb. 11 Fig.
GB View of the hood Attention 1. Control panel 2. Operating light 3. Grease filters When installed, the hood must be not less than 60 cm. above electric burners or 70 cm. above gas or mixed-fuel burners. Mounting of grease filters Warning! Attention! The grease filters are supplied not mounted and packed in order to avoid damages during transport of the hood. — The hood cannot be connected to flues of other appliances that run on energy sources other than electricity.
GB i. The hood is supplied with installation fittings suitable for most kinds of ceilings, but in any case a qualified installation technician must be consulted in order to choose the best mounting solution. j. Fix the upper and lower part of the utter chimney together temporarily with one screw O 2,9x6,5 (Fig. 7). k. Fix the upper part of the chimney to the supporting structure with two screws P 2,9x6,5 (Fig. 7). l. Fit four auto locking nuts on the four pins located on the upper side of the hood (Fig. 8).
GB Using the hood The hood has one variable speed motor. For the best performance, we recommend using the low speeds in normal conditions and the high speeds in particular cases of strong odour and vapour concentration. We recommend starting up the hood a few minutes before cooking and keeping it running until all the odours have been eliminated. O A A B E F C D G H I - 1 B E 2 3 F C F C D G O I H I Motor OFF button ON button and motor speed selection button 1 - 2 - 3 - 1 - 2 - . . . .
GB flash even if the hood is used in the exhausting version (i.e. without carbon filter). To stop the led flashing, press the two buttons as described above. Changing the lighting elements Before performing any maintenance operation, disconnect the hood from the electricity. a. With the help of a screwdriver remove the screw that secures the lamp cover (Fig. 11). b. Remove the lamp cover. c. Replace the damaged part with one of equal rating (PL 9Watt max.). d.
ELECTROLUX - ZANUSSI HAUSGERÄTE GMBH Rennbahnstraße 72-74 D-60528 Frankfurt LI08IA
