Montage- und Gebrauchsanweisung für den Dunstabzug Instruction on mounting and use of the cooker hood JDK 7130, JDK 8130 JDK 7240, JDK 8240 1
4 3 3 1-2 1 2 Abb. 2 Fig. 2 Abb. 1 Fig. 1 I Abb. 4 Fig. 4 Abb. 3 Fig.
Abb. 5 - Fig.
— No food must be cooked flambé underneath the hood. The use of an unprotected flame is dangerous for the filters and could cause fires. Therefore, never use an open flame under the hood. When frying foods, never leave the pan alone because the cooking oil could flare up. — Please, keep to the provisions of official directives regarding the question of fume discharge.
Mounting the hood - Fig. 5 Operation a. Put the template onto the wall and drill two Ø12mm holes. b. Fit two hooks (1) on the drilled holes. c. Hang the hood on the hooks and adjust the position of the hood using the two screws on the bottom of the hooks (4). d. Remove the metal filters (3) and from the inside of the hood mark two point (2). Remove the hood and drill two Ø8mm holes on the marked points.
e) Refit the exhaust grate or the grease filter. Replacing the lamp a) Disconnect the hood from the electricity. b) Remove the grease filters (Fig. 2). c) Always replace burnt-out lamps with 40Watt max. (E14). d) Fit again the grease filters. e) Before calling for repair service because the hood fails to light up, make sure the bulbs are screwed in tightly. Before calling for Repair Service because the hood fails to light up, make sure the lamp is well-inserted.
ELECTROLUX HAUSGERÄTE GMBH Rennbahnstraße 72-74 60528 Frankfurt L 857 Ed.