User manual

The furniture door
The door on this appliance is designed for the
overlay of a panel having the following dimensions:
Width 596 mm
Height 604 mm max
Thickness 20 mm max
Weight 2 - 7.5 kg max
The panel height should be no more than
indicated, otherwise complete opening of the
door will not be possible as the furniture door
panel will hit against the dishwasher plinth.
It is possible to line up the control panel to
correspond with the height of the drawers of the
adjacent pieces of furniture, to co-ordinate with the
style of the rest of the unit furniture in your kitchen.
Add one or more of the fillets provided until you
reach the desired height.
Secure the fillets as shown in the picture, by
means of two screws 4 x 40 provided.
Prepare the panel as follows:
1. Measure the distance (B) between the part
below the control panel (or fillets) and the
reference notch (X) on the door.
2. Drill the panel with a Ø 2 x 14 bit according to
the measurements given in the picture.
3. Screw the two fastening pivots in the holes
indicated in the picture.
4. Mount the decor panel by inserting the two
fastening pivots into the slotted holes of the
door. Lift the decor panel until perfect
alignment with the facia panel is obtained.
5. Once the correct position has been found, open
the door and fasten the decor panel by means
of the four 4 x 40 screws provided, using the
holes through the inner door.
45
PFI44GB
II04
A
A
B
X
=
=
525
B
2
1
II91
II83
II84