Installation Guide

FOR LED DECORATIVE PENDANTS
INSTALLATION INSTRUCTIONS
6 Back-off two canopy screws enough to remove mounting plate.
7 Pass building wires through large hole of mounting plate. Securely
attach mounting plate to J-Box using 2 screws.
8 Use aluminum tube to thread pendant cord through the shade.
9 Back-off but do not fully remove the set screw in the nipple. U se the
aluminum tube to help thread the pendant cord through the nipple. Once
a length of cord is through the canopy, slide the aluminum tube out of
the canopy completely and slide it down to meet the shade.
10 Make electrical connections as shown in the illustration. If a building
ground wire is present, connect the canopy’s bare ground wire using
a wire nut. If no building ground wire is present and the building wiring
is grounded using metallic conduit, wrap the bare ground wire around
the green grounding screw and tighten screw.
11 Adjust the length of cord coming out of the canopy close to the desired
length. Gently tighten set screw.
12 Neatly coil and stow excess cord inside the canopy. Attach canopy
to mounting plate and tighten 2 screws.
13 Minor adjustment in pendant cord length, up or down, can be made
by backing-off set screw. When satisfied with length, tighten set screw.
Do not over-tighten as this may short out cable.
© 2011 Juno Lighting, LLC. Rev 10/11 P3249 pg 1 of 1
WARRANTY
Juno Lighting Group provides five year limited warranty on LED components from date of purchase. Juno Lighting Group’s
obligation is expressly limited to repair or replacement, without charge, at Juno Lighting Group’s factory after prior written return
authorization has been granted. This warranty shall not apply to products which have been altered or repaired outside of Juno
Lighting Group’s factory. This warranty is in lieu of all other warranties, expressed or implied, and without limiting the generality of
the foregoing phrase, excludes any implied warranty of merchantability. Also, there are no warranties which extend beyond the
description of the product on the company’s literature setting forth terms of sale.
Product Services Phone [phone]
1300 South Wolf Road • Des Plaines, IL 60018 • Phone [phone] • www.junolightinggroup.com
IMPORTANT SAFETY INSTRUCTIONS
1 Read all instructions completely before beginning installation. Keep these
instructions in a safe place for future reference.
2 To reduce the risk of fire and burns, do not install pendant cords where the
exposed conductor can be short circuited or contact any
electrically conductive material.
3 Do not install any shade closer than 6 inches (15.25cm) from curtains
or similar combustible materials.
4 To reduce the risk of over-heating or fire, make sure all connections
are tight.
5 Turn off the electrical power before starting installation, before re-lamping, or
modifying the lighting system in any way.
WARNING
TURN OFF POWER TO THE JUNCTION BOX BEFORE INSTALLATION.
CAUTION
ELECTROSTATIC DISCHARGE SENSITIVE
This product uses components that can be damaged by electrostatic discharge
(ESD). Do not remove diffuser ball or touch without proper grounding.
SAVE THESE INSTRUCTIONS
TRANSFORMER
CANOPY
TEMPORARILY
USE ALUMINUM
TUBE HERE TO
THREAD CORD
ALUMINUM TUBE
MOUNTING PLATE
SHADE
LED LAMP ASSEMBLY
DIFFUSER BALL
(PROVIDED)
MUST BE INSTALLED
6
7
9
8
13
11
12
10