Installation Guide

For Juno R Series Trac Connectors, Electrical Feeds and Accessories
Juno R series connectors, electrical feeds and accessories are to be used only with Juno R Series Trac. Some Juno R Series Connectors can also be used as
Electrical Feeds as noted. All Juno Trac Components are both mechanically and visually polarized to assure proper connections and to simplify installation.
• Trac face has polarity line indicating positive side
• Trac connectors have embossed arrow which must point towards the Trac polarity line when installed.
Important: Completely read instructions before attempting installation. Electrical Rating: 120V, 60Hz and 20 amp max
R38 End Feed
(For Electrical Feed Away From Junction Box)
Makes electrical connection from BX, Romex or Greenfield. Use at end of Trac run when
wiring from above.
1. Make sure power is OFF.
2. Remove connector cover.
3. Attach 1/2’’ connector (not supplied) and secure to BX, Romex or Greenfield.
4. Insert End Feed connector fully into Trac section with polarity arrow pointing toward
Trac polarity line, secure with set screw.
5. Attach Trac to ceiling following instructions supplied with the Trac section.
6. Fasten positive wire to screw terminal marked “P”.
7. Fasten neutral wire to screw terminal marked “N”.
8. Replace cover and secure with screw.
R38 End Feed
INSTALLATION INSTRUCTIONS
WARRANTY
Limited warranty located at:
www.acuitybrands.com/customerresources/terms_and_conditions.aspx
1 of 1
1300 S. Wolf Road • Des Plaines, IL 60018 • Phone [phone] • Visit us at www.acuitybrands.com/juno-trac
©2017 Acuity Brands Lighting, Inc. Rev 3/17 P3090
Technical Services Phone [phone]