Operating Guide

REV-7/14
DIMENSIONS
4” MINIATURE UNIVERSAL
TC NEW CONSTRUCTION
HOUSING
INCANDESCENT LAMPS
TC1
G3.1.1
Project:
Fixture Type:
Location:
Contact/Phone:
5 3/8"
12 1/8"
13 1/2"
Will expand
to 25"
(Reduces to 8 1/2"
with breakaway
feature)
6 3/4"
9 1/8"
ACCESSORIES
Catalog No. Description
4TSA Torsion Spring Adapter (for original style housing)
GU10-WHIP GU10 Socket Whip
To order, specify catalog number.
PRODUCT CODES
Catalog Number Input Voltage Lamp Rating (max.)
TC1 120V
R14/R16/R20/PAR16/PAR20 (See reverse for max. trim rating)
4 1/2” CEILING CUTOUT
PRODUCT DESCRIPTION
TC New Construction Housing design for use in non-insulated
areas • If installed where insulation is present, the insulation must
be pulled back 3” from all sides of the TC housing.
PRODUCT SPECIFICATIONS
Lamp Lamp ratings based on trim selected – see reverse side.
Socket Detachable medium base porcelain with nickel-plated
copper screw shell.
Trims Trim selection shown on reverse side.
Labels U.L. listed for through-branch wiring, damp locations and
IP • Product thermally protected against improper use of lamps
or insulation • Union made • UL Listed/CSA certified • Trim No.
11, 12, 4101, 4102 and 4181 are wet location approved for
covered ceiling applications • Trims 14, 17 are wet location
approved for covered ceiling applications, when used with
outdoor rated lamps.
Testing All reports are based on published industry procedures;
field performance may differ from laboratory performance.
Product specifications subject to change without notice.
INSTALLATION
Real Nail 3 Bar Hangers Telescoping Real Nail
®
3 system
covered
under Patent D552,969
permits quick placement of housing
anywhere within 24” O.C. joists or suspended ceilings • Integral
T-bar notch and clip secures housing in suspended ceiling grid –
no accessory clips required • 24” expansion stop allows quick
placement of fixture in standard grid spacing • Bars scored in two
locations for fast, clean breaking, allowing housing installation
in tight applications • Bars captive to mounting frame • Edge-
mounted for extra strength • Captive bugle-headed ring shank
nail for quick one-step installation and easy removal with claw
hammer for fixture relocation • Quick-Loc slot (location identified
on the mounting frame) and oversized locking set screw lock
fixture in position • Bar hanger foot contoured to align to bottom
of construction joist • Alternate mounting holes included.
Junction Box Pre-wired junction box provided with (5)
1
2” and
(1)
3
4” knockouts, (4) Non-metallic sheathed cable connectors and
ground wire, U.L. listed/CSA certified for through-branch wiring,
maximum 8 No. 12 AWG 90˚ C branch circuit conductors (4 in,
4 out) • Junction box provided with removable access plates
• Knockouts equipped with pryout slots.
Mounting Frame 22-gauge die-formed galvanized steel
mounting frame • 9
1
8” L x 6
3
4” W, (excluding bar hangers)
• Rough-in section (junction box, mounting frame, housing and
bar hangers) fully assembled for ease of installation.
Housing TC housing, 22-gauge galvanized steel • Housing
is vertically adjustable to accommodate up to a 1
1
/
4
” ceiling
thickness.

Summary of content (2 pages)