Operating Guide
REV-7/14
DIMENSIONS
4” LOW VOLTAGE UNIVERSAL
TC NEW CONSTRUCTION
HOUSING
50W MR16
TC44
G3.2.1
Project:
Fixture Type:
Location:
Contact/Phone:
5 3/8"
13 1/2"
Will expand
to 25"
(Reduces to 8 1/8"
with breakaway
feature)
6 3/4"
9 1/8"
12 1/8"
4 1/2” CEILING CUTOUT
ACCESSORIES
Catalog No. Description
4TSA Torsion Spring Adapter (for original style housing)
To order, specify catalog number.
PRODUCT CODES
Catalog Number Input Voltage Lamp Rating (max.)
TC44 120V
12V 50W MR16
PRODUCT DESCRIPTION
TC New Construction Housing design for use in non-insulated
areas • If installed where insulation is present, the insulation must
be pulled back 3” from all sides of the TC housing.
PRODUCT SPECIFICATIONS
Lamp One 12V, 50W MR16 lamp.
Socket Ceramic bi-pin socket with aluminum heat shield.
Trims Trim selection shown on reverse.
Transformer 120V to 12V 50VA thermally protected magnetic
transformer mounted to junction box.
Dimming May be dimmed using dimmers specifically designed
for low voltage magnetic transformers; consult factory or dimmer
manufacturer for additional information.
Labels U.L. listed for through-branch wiring, damp locations and
IP • Product thermally protected against improper use of lamps
or insulation • Union made • UL Listed/CSA certified • Trim
No. 441, 4401, 4402 and 4481 are wet location approved for
covered ceiling applications.
Testing All reports are based on published industry procedures;
field performance may differ from laboratory performance.
Product specifications subject to change without notice.
INSTALLATION
Real Nail 3 Bar Hangers Telescoping Real Nail
®
3 system
covered
under Patent D552,969
permits quick placement of housing
anywhere within 24” O.C. joists or suspended ceilings • Integral
T-bar notch and clip secures housing in suspended ceiling grid –
no accessory clips required
• 24” expansion stop allows quick placement of fixture in
standard grid spacing • Bars scored in two locations for fast,
clean breaking, allowing housing installation in tight applications
• Bars captive to mounting frame • Edge-mounted for extra
strength • Captive bugle-headed ring shank nail for quick one-
step installation and easy removal with claw hammer for fixture
relocation • Quick-Loc slot (location identified on the mounting
frame) and oversized locking set screw lock fixture in position
• Bar hanger foot contoured to align to bottom of construction joist
• Alternate mounting holes included.
Junction Box Pre-wired junction box provided with (5)
1
⁄2” and
(1)
3
⁄4” knockouts, (4) Non-metallic sheathed cable connectors and
ground wire, U.L. listed/CSA certified for through-branch wiring,
maximum 8 No. 12 AWG 90˚ C branch circuit conductors (4 in,
4 out) • Junction box provided with removable access plates
• Knockouts equipped with pryout slots.
Mounting Frame 22-gauge die-formed galvanized steel
mounting frame • 9
1
⁄8” L x 6
3
⁄4” W, (excluding bar hangers)
• Rough-in section (junction box, mounting frame, housing and
bar hangers) fully assembled for ease of installation.
Housing TC housing, 22-gauge galvanized steel • Housing
is vertically adjustable to accommodate up to a 1
1
⁄4” ceiling
thickness.