Operating Guide

REV-2/09
DIMENSIONS
SLOPE CEILING TC REMODEL HOUSING
STANDARD SLOPE:
2/12 to 6/12 PITCH (9˚ to 27˚)
INCANDESCENT LAMPS
TC926R
G4.1.2
Project:
Fixture Type:
Location:
Contact/Phone:
9" MAX
7 1/2" MIN
6 1/2"
x 6 7/8"
Ceiling Cutout
14"
GTE
GTE
R
P
R
P
6 7/8"
PRODUCT CODES
Catalog Number Input Voltage Lamp Rating (max.)
TC926R 120V A19/MR16/BR30/R30/PAR30/PAR30L/PAR38
PRODUCT DESCRIPTION
Slope ceiling TC Remodel Housing for remodel application where
back side of ceiling is not accessible • Installs through an opening
in ceiling from below • Secures in place with factory supplied
remodel clips • Designed for use in non-insulated areas • If
installed where insulation is present, the insulation must be pulled
back 3” from all sides of the TC housing.
PRODUCT SPECIFICATIONS
Lamp Lamp ratings based on trim selected – see reverse.
Socket Medium base porcelain with nickel-plated copper screw
shell • Adjustable to position lamp perpendicular to floor.
Trims Trim selection shown on reverse.
Labels U.L. listed for through-branch wiring, damp locations and
IP • Product thermally protected against improper use of lamps or
insulation • Union made • UL Listed/CSA certified • Trim No.
610 is wet location approved for covered ceiling applications.
Testing All reports are based on published industry procedures;
field performance may differ from laboratory performance.
Product specifications subject to change without notice.
INSTALLATION
Junction Box Pre-wired junction box, UL listed/CSA certified for
through-branch wiring maximum 4 No. 12 AWG 90˚ C branch
circuit conductors (2 in, 2 out) • Junction box provided with
removable access plate, (4)
1
⁄2” knockouts, (4) Non-metallic
sheathed cable connectors and ground wire • Knockouts
equipped with pryout slots.
Housing TC housing, 22-gauge white painted steel with
aluminum cap • Housing is vertically adjustable to accommodate
up to a 1” ceiling thickness • Designed to fit 2x8 or 2x10
construction.