Installation Guide

1300 S. Wolf Road • Des Plaines, IL 60018 • Phone [phone] • Visit us at www.acuitybrands.com/juno-undercabinet
©2017 Acuity Brands Lighting, Inc. Rev 5/17 P5013
1 of 2
INSTALLATION INSTRUCTIONS
UDWM Direct Wire Module
For use with Juno ULH Series Undercabinet Fixtures
This Direct Wire Module is for use with Juno ULH Series undercabinet fixtures. This Module is designed to be wired with Flat
Non-Metallic Cable (NMB) (2C+Ground), or Flexible Metal Conduit (BX).
NOTE: Electrical connector for BX installations is supplied with fixture or may be purchased separately.
1. Read all instructions before beginning installation.
Safely store these instructions for future reference.
2. This module is for use with Juno ULH fixtures and
accessories. Do not use this module or the provided
jumper cord with any other products.
3. WARNING: FOR MULTIPLE FIXTURE INSTALLATIONS,
MAKE CERTAIN FIXTURES ARE CONNECTED TO
BRANCH CIRCUIT AT ONLY ONE FEED POINT.
4. CAUTION: Do not exceed 5 AMPS maximum load
5. For use with 120V 60Hz. power supply only.
For interior use only.
6. WARNING: DO NOT ELECTRIFY THE MODULE UNTIL
THE FOLLOWING CONDITIONS HAVE BEEN MET:
a. MOUNTING AND WIRING OF MODULE IS COMPLETE.
b. THE MODULE COVER HAS BEEN INSTALLED WITH
SCREWS & LOCKWASHERS SECURELY FASTENED.
c. ALL FIXTURES CONNECTED TO MODULE HAVE
BEEN MOUNTED AND THEIR DIFFUSERS / LENSES
HAVE BEEN PROPERLY INSTALLED.
d. ALL OPEN ELECTRICAL PORTS ON CONNECTED
FIXTURES ARE COVERED WITH ELECTRICAL PORT
COVERS PROVIDED WITH THE FIXTURES.
7. WARNING: TO PREVENT OVERHEATING DO NOT
INSTALL IN SMALL ENCLOSED SPACES.
TO PREVENT ELECTRICAL SHOCK DO NOT INSTALL
IN WET ENVIRONMENTS.
8. Qualified electricians, in accordance with local electrical
codes, should perform all installations.
9. Fixtures may be dimmed using quality household dimmers
or dimmer systems designed for non-inductive loads.
For best dimming performance, use dimmer systems
specifically designed for low voltage electronic transformers.
10. Always disconnect electrical power from this product before
cleaning or servicing.
11. Do not operate this product if jumper cord has
been damaged.
12. Keep jumper cord away from sources of heat and
heated surfaces.
13. Do not operate this product in environments where
aerosol sprays are being used or where oxygen is
being administered.
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS