iCharger 4010DUO Battery Charger Manual

iCharger
iCharger
iCharger
iCharger Synchronous
Synchronous
Synchronous
Synchronous Balance
Balance
Balance
Balance Charger/Discharger
Charger/Discharger
Charger/Discharger
Charger/Discharger 4010DUO
4010DUO
4010DUO
4010DUO
- 11 -
Note: Different types of battery and program have different multipage information display, see detai ls
as below :
Press STATUS-
STATUS-
STATUS-
STATUS- x
x
x
x button for 2S
2S
2S
2S when running program to pop up MODIFY interface , to modify the current , discharge
voltage, parameter s on line , as below :
Press STOP
STOP
STOP
STOP /
/
/
/ START-x
START-x
START-x
START-x button when running program to stop running , and press STOP/START-x
STOP/START-x
STOP/START-x
STOP/START-x button again to return
to the initial interface.
●
●
●
● Error
Error
Error
Error Message
Message
Message
Message s
s
s
s
When the 4010DUO is running, the system will stop the channel immediately and pop up the red dialog box and the
buzzer alarms if it detects an error, as below:
Types of battery Cells IR Info Cycle
LiXX √ √ √ √
NiXX × × √ √
Pb × × √ √
1
3
5
2
4
6
1
2
Information page
1: Power
2: End voltage
3:Lowest input voltage
4: Safety time
5: Temp. cutoff
6: End charge capacity
1
C ycle charge status
1: C ycle charge status
Error Messages Status
1: Error number
2: Error message
See all details in Page35 Error
Error
Error
Error Messages
Messages
Messages
Messages in
Appendix