iCharger 4010DUO Battery Charger Manual

ManualsBrandsJunsi ManualsBattery ChargersICharger 4010DUO Multi-Chemistry DC Battery Charger (10S/40A/2000W)

iCharger

iCharger Synchronous

Synchronous

Synchronous Balance

Balance

Balance Charger/Discharger

Charger/Discharger

Charger/Discharger 4010DUO

4010DUO

- 13 -

① LiXX

LiXX

LiXX Battery

Battery

Battery Charge

Charge

Charge Setup

Setup

Select

Program → Charg e

to enter

Charge

setup interface .

Note: 1.The charger first charges with constant current (CC) according to the user setting then turns

to constant voltage (CV) when the charging voltage reaches the peak point. In the CV phase

the current gradually falls, and the charger will terminate charging when the current falls

below than percent of the configured charge current.

2.Charge mode has

Balance, Not Balance

two modes available, when choose

Balance

mode,

balance board must be connected except for connecting 1S battery. The balance charge

mode is for balancing the voltage of battery cells while charging. In this mode the battery

balance lead must be connected to the balance port, and the charger can monitor the

voltage of individual cells and adjust the input current fed into each cell to normalize the

voltage.

3.Tick

Show

to display this program on

MEMORY SETUP

, and the built-in program is ticked by

default.

4. When the value of charge cells voltage exceeds the recommended value (LiPo

4.2V,

LiIo

4.1V,

LiFe 3.6V), there will alarm and beep tones . As long as the users change the value, the main

charging interface, "battery types" and "cells voltage" setting value will displayed alternately.

Switch to

Balance

mode on

Chg Mode

to active " " button and click to enter

Balance

mode setup interface.

Switch to

User

mode on

Balance Speed

to active

Balance Diff , Balance Set Point , Balance Over Charge , Balance

Done Delay

setting , after setting click " " to return to the previous interface .

LiXX Battery Charge Program Setup

Chg Current:

0.05A-40A ; default : 2A

Chg Mode:

Balance (default), Not Balance

Chg End Current:

1%-50%; default : 10%

Chg Cell

Volt:

3.85V/Cell-4.35V/Cell ;

Default : 4.2V/Cell

LiXX Battery Balance S etup

Balance Start:

CV,

CV-0.1V--1V, Always

Default: CV -0.2 V

Balance Speed:

User , Fast ,

Normal （ default ） , Slow

LiXX Battery Charge Balance Setup

Balance Diff : 1mV-10mV ; default : 5mV

Balance Set Point: 1mV-50mV ; default : 5mV

Balance Over Charge : 0mV-10mV ; default : 0mV

Balance Done Delay : 0Min-20Min ; default : 1Min