iCharger 4010DUO Battery Charger Manual

ManualsBrandsJunsi ManualsBattery ChargersICharger 4010DUO Multi-Chemistry DC Battery Charger (10S/40A/2000W)

iCharger

iCharger Synchronous

Synchronous

Synchronous Balance

Balance

Balance Charger/Discharger

Charger/Discharger

Charger/Discharger 4010DUO

4010DUO

- 15 -

② LiXX

LiXX

LiXX Battery

Battery

Battery Storage

Storage

Storage Setup

Setup

This mode is for storaging LiXX battery that is not to be used for an extended period. The charger determines whether

to charge or discharge the battery based on the configured target voltage. If the battery voltage exceeds the target

storage voltage it will start to discharge, while lower than the target storage voltage it will start to charge.

Select

Program → Storage

to enter

Storage

setup interface .

Note:1.

Accelerated storage:

accelerated storage via internal resistance correction. Tick

Accelerated

storage

to accelerated storage.

2 .

Storage Compensation

is the compensation for the battery voltage fallback: for storage charge,

the actual storage voltage=Storage Cell Voltage + Storage Compensation; for storage discharge,

the actual storage voltage=Storage Cell Voltage - Storage Compensation.

③ LiXX

LiXX

LiXX Battery

Battery

Battery Discharge

Discharge

Discharge Setup

Setup

Select

Program → Discharge

to enter

Discharge

setup interface.

Note: 1.The charger first discharges with constant current (CC) according to the user setting then

turns to constant voltage (CV) when reaches the discharged voltage. In the CV phase the

current gradually falls, and the charger will terminate discharging when the current falls

below than percent of the configured discharge current.

For example: the default value of Discharge Current is 2A, the default value of End

Current is 50%: End Current=2A*50%=1A.

2. Regenerative mode has

OFF ,

input,

channel

three modes available, see more details

in Page32 Important

Important

Important Notes

Notes

Notes .

When switch to

channel

Regenerative Mode

, “ " button changes to the operational state, click to enter

channel

setup interface , after setting click " " to return to the previous interface.

Note: This setting is mainly in charge of controlling the regenerative voltage and current, to prevent the

charger from being damaged by regenerative charge.

Storage Cell V oltage

: 3.7V/Cell-3.9V/Cell ;

Default : 3.85V/Cell

Storage Compensation

: 0V/Cell-0.2V/Cell;

Default : 0. 01 V/Cell

LiXX B attery Discharge setup

Discharge Current :

0.05A-40A ; default : 2A

Discharge Voltage

: 3V/Cell-4.1V/Cell ;

Default : 3.5V/Cell

End Current

: 1%-100% ; default : 50%

Regenerative Mod e:

OFF (default),

input,

channel

LiXX

LiXX Battery

Battery

Battery Channel

Channel

Channel Regenerative

Regenerative

Regenerative Setup

Setup

Channel Joi n:

Not available

Voltage Limit :

0.1V-40V ; default : 12V

Current Limit :

0.05A-40A ; default : 1A