iCharger 4010DUO Battery Charger Manual

ManualsBrandsJunsi ManualsBattery ChargersICharger 4010DUO Multi-Chemistry DC Battery Charger (10S/40A/2000W)

iCharger

iCharger Synchronous

Synchronous

Synchronous Balance

Balance

Balance Charger/Discharger

Charger/Discharger

Charger/Discharger 4010DUO

4010DUO

- 31 -

Important

Important Notes

Notes

● Channel

Channel

Channel Mode

Mode

1 . Channel Asynchronous Mode : i.e. CH-1 and CH-2 work independently .

Picture1:

Picture1: Error

Error

Error Connection

Connection

Connection Picture2:

Picture2:

Picture2: Correct

Correct

Correct Connection

Connection

Go to

MEMORY SETUP → Option → Channel Mode

to select

Asynchronous

Note: O n this mode, the two channels must have not any external electrical connection; otherwise it

will damage the charger . Cannot charge with connection as shown in picture 1, the correct

connection is shown in picture2.

2 . Channel Synchronous Mode: i.e. CH-1 & CH-2 are controlled at the same time to charge/discharge one battery

pack.

Picture 3

Go to

MEMORY SETUP → Option → Channel Mode

to select

Synchronous .

On this mode, the maximum current can up to 70A, power capacity is the sum of two channels limit.

Note: The two channels charge one battery pack simultaneously must connect as shown in picture 3,

and the two channels must work in synchronous mode, or it will damage the charger.

Synchronous mode display :

1: The total voltage of dual-channel

2: The total current of dual-channel

3: The total capacity of dual-channel

4: Channel current & voltage difference