User's Manual

 Rev0.0
 Page8of

In the users manual of the end product, the end user has to be informed to keep at least
20cm separation with the antenna while this end product is installed and operated. The
end user has to be informed that the FCC radio-frequency exposure guidelines for an
uncontrolled environment can be satisfied. The end user has to also be informed that
any changes or modifications not expressly approved by the manufacturer could void the
user's authority to operate this equipment. If the size of the end product is smaller than
8x10cm, then additional FCC part 15.19 statement is required to be available in the
users manual: This device complies with Part 15 of FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference and (2)
this device must accept any interference received, including interference that may cause
undesired operation.
8
Labelling Requirements
The Original Equipment Manufacturer(OEM) must ensure that FCC labelling
requirement are met. This includes a clearly visible label on the outside of the OEM
enclosure specifying the appropriate JUNSUNGTECH Co., Ltd. FCC identifier for this
product as well as the FCC Notice above.
The FCC identifier is FCC ID: XNKJSWAM83. In any case the end product must be
labeled exterior with "Contains FCC ID: XNKJSWAM83".
If the size of the end product is larger than 8x10Cm, then the following with Part15.19
statement has to also be available on the label: This device complies with Part15 of
FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Page 9 of 9