User's Manual

User manual

Step1： Install the Wireless HD receiver equipment

a) Connect the receiving device to HD displayers (LCD, LED, etc.) using the VGA cable;

b) Connect 5V DC power adapter to the receiving device, and turn on the power switch.

Step2： Install the wireless HD transmitter equipment

a) The transmitting device is connected directly to the HD signal source ( laptop computer, PS3 or others)

by the VGA interface;

b) Connect the USB connector of the transmitter to computer USB Interface, or a USB power adapter.

Step3：Connect the device transmitting the signal source

a) The wireless connection will establish automatically, During this time the blue light of wireless HD

transmitter will flash, After the wireless connection complete, the blue light keeps bright. The entire

process of the connection takes about 15 seconds.

Figure 1 Schematic diagram of the wireless HD video systems to connect

Troubleshooting

Step1：

Wireless HD receiver device is

connected to HD displays

Step2：

Wireless HD transmitter device is

connected HD sources

Step3：

Wait for the wireless

connection about 15

seconds

Wireless HD receiver equipment

Wireless HD transmission equipment

Source: PC，PS3….

5V 2A adapter

VGA cable

Monitor：LCD、LED……

USB power

Note: See Troubleshooting (2,3 pages)

- If the PC does not support automatic image output, you need to do it manual.

- Connect the Transmitter to the video player or an external display device, if there is no USB power supply

interface, you can use USB power adapter.

- If the wireless connection can’t connect successfully, you can try using the remote control POWER button to

restart the receiver. The receiver will reboot automatically and try to connect to the transmitter again.

PAGE 1
User manual User manual Step1： Install the Wireless HD receiver equipment a) Connect the receiving device to HD displayers (LCD, LED, etc.) using the VGA cable; b) Connect 5V DC power adapter to the receiving device, and turn on the power switch.
PAGE 2
User manual Before reading this chapter, please do the following confirmation: 1) Connect the source and displayers directly through the VGA cable and watch if it can transfer images, if you still can’t watch the transfer images and sound, you need to make sure the signal source or displayer problems. 2) To confirm the source of the VGA port is working properly, please check if the notebook graphics driver installation complete.
PAGE 3
User manual Figure 2 Figure 3 Figure 4 3 Some noise in picture on monitor 1) Try to reduce the distance between the wireless transmitter and the receiver. 2) Try to change display resolution 3) Reset the connection of the transmitter and receiver. 4 No sound on the receiver side. 1) Confirm the source of the graphics driver is installed correctly. 2) Make sure the external display device is not set to mute mode. This device complies with part 15 of the FCC Rules.