Installation Instructions

FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
(1)This device complies with FCC radiation exposure limits set forth for an uncontrolled environment and it also
complies with Part 15 of the FCC RF Rules.
(2)This equipment should be installed and operated with minimum distance 20 cm between the radiator & your body.
Caution
Any changes or modifications not expressly approved by party responsible for compliance could void the user’s
authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
Note
(1)the manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications
to this equipment.
(2)To avoid unnecessary radiation interference, it is recommended to use a shielded RJ45 cable.
This device complies with part 15 of the FCC Rules.Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received, including interference that may cause undesired operation.