Owner's Manual

4 Preparation
15
TPlace a cup under the coffee spout.
T Press the
]
button for about 2 seconds.
The coffee flows into the cup.
TPress any button as soon as there is sufficient coffee in the cup.
Preparation stops. The set amount of water for one coffee is
permanently stored.
E You can alter this setting at any time by repeating the above
procedure.
You can adjust the grinder to suit the degree of roast of your coffee.
If you adjust the consistency of grind when the grinder is not
operating, the grinder adjustment switch could be damaged.
TOnly adjust the consistency of grind when the grinder is
running.
E The consistency of grind is correct if the coffee flows
regularly from the coffee spout. In addition a fine, thick
crema forms.
Grinder adjustment switch
U
1: Fine consistency of grind setting
U
2: Coarse consistency of grind setting
Example:Proceed as follows to change the consistency of grind
during the preparation of an espresso.
TPlace a cup under the coffee spout.
TOpen the cover of the filler funnel for ground coffee.
T Press the
[
button.
TTurn the grinder adjustment switch to the desired position
while the grinder is running.
The preset amount of water flows into the cup.
TClose the filler funnel cover.
You can choose to use a second coffee variety, for example
decaffeinated coffee, with the filter funnel for ground coffee.
Basic information about ground coffee:
U
Never add more than two level measuring spoons of ground
coffee.
U
Use ground coffee which is not ground too finely. Very fine
coffee can block up the system so that the coffee only comes
out in drips.
Adjusting the grinder
CAUTION
wq
Ground coffee