Operation Manual

14
2 Preparation
2 Preparation
Basic information about preparing drinks:
U
During the grinding operation you can select the coffee
strength of single products by turning the Rotary Switch:
MILD, NORMAL, STRONG or EXTRA.
U
During preparation, you can change the preset amounts (e.g.
amount of water or milk foam) by turning the Rotary Switch.
U
You can stop preparation at any time. Just press the Rotary
Switch (for a speciality coffee) or return the switch to its origi-
nal position (for milk foam and hot water).
U
The last speciality coffee prepared is always displayed, even if
the D6 was switched off in the meantime.
Coffee tastes best served hot. A cold porcelain cup cools the bever-
age – and impairs the taste. We therefore recommend prewarming
the cups. The full coffee aroma can develop only in prewarmed cups.
You can purchase a JURA cup warmer from your specialised dealer.
You can make permanent settings for all products in programming
mode (see Chapter 4 ‘Permanent settings in programming mode –
Product settings’).
Espresso and coffee are both prepared following this model.
Example:Proceed as follows to prepare one coffee.
Precondition:
CAPPUCC. is displayed (example).
T Place a cup under the coffee spout.
T Turn the Rotary Switch until
COFFEE is displayed.
T Press the Rotary Switch.
Preparation starts.
COFFEE and the coffee strength are
displayed. The preset amount of water for coffee flows into
the cup.
Preparation stops automatically.
COFFEE appears on the
display.
Espresso and coffee